HUGE SAVINGS
On All Lifetime Warranted Cedar Bat Houses
Premier Series:
All Premier Series bat houses are approved by Bat Conservation International. Constructed from high quality rough sawn CEDAR, 13/16" outer wall construction and 9/16" chamber walls.
Select a product and options below. Click add to cart to update.
Single chamber bat house. Dimensions: 29H x 16W x 2.125D inches. Capacity: Approximately 100 bats.
We Pay All Shipping Charges for orders shipped in the lower 48 states!
Double chamber bat house. Dimensions: 29H x 16W x 3.5D inches Capacity: Approximately 200+
Triple chamber bat house. Dimensions: 29H x 16W x 5D Capacity: Approximately 330 Bats
Four chamber bat house. Dimensions: 29H x 19W x 6.5D Inches. Capacity: Approximately 530 Bats
Five chamber bat house. Dimensions: 29H x 19W x 7.75D inches. Capacity: Approximately 675 Bats
Note: Mounting Brackets purchased along with a Premier Series Bat House qualify for FREE SHIPPING. To qualify, be sure to select desired bracket from the drop down menu accompanying each bat house selected.
POWDER COAT FINISH
Steel pole mounting brackets are fabricated from 1/4 inch thick steel tube 3 x 3 inches square and 1/8 x 2 inch steel support arms with slotted mounting holes for the bat house. Brackets are designed with two holes tapped into the sides of the 3 x 3 inch receiver tube to accept bolts and jam nuts for fastening to the pole.
All hardware included.
This unit was designed so it can be used with 1-1/2 inch (1-13/16” OD), or 2 inch (2-3/8” OD) black pipe and can be used to mount any of our Premier Series Bat Houses.
This unit is constructed in the same manner as the single house mounting bracket with the exception to an additional arm for mounting two bat houses back to back.
We recommend only using a 2 inch pole for this application and no more than two 3 chamber units.
Wood Post or Pole Single Unit Mount Bracket is constructed from 2 inch x 1/8 inch steel mounting arms for the bat house and 1 inch x 1/8 inch mounting arms for the post or pole attachment.
You can use this mounting unit to attach your Bat House to a square or rectangular wood post or a wood pole up to 12-1/2 inches wide.
We do not recommend attachment to trees, dead or alive.
The wall mounting unit was designed and constructed for the application of direct attachment of a bat house to a wall surface, be it on a residence or commercial structure.
Wall bracket Single unit is constructed with 2 inch x 1/8 inch steel welded solid at all points. It has slotted areas within the steel for mounting the bat house and attachment to a wall.
This unit will hold the bat house away from the wall 5 inches and helps to decrease or eliminate the bat guano droppings from hitting the wall area.
This unit will support any one of our 5 different model bat houses that we sell.
All hardware for mounting the bat house to the brackets is included.
(Note: Hardware to mount the bracket to the structure surface is not included because there are so many different application possibilities, depending on the structure construction.)